More Radial Arm Saw Adjustments

It has been years since the radial arm saw came into my shop, and I have not used it at all because it was not set up accurately. I've been working on fixing this over the last two weeks, and I'm getting quite familiar with the settings.

The thing that took me longest, was getting the table to be nearly perfect in its alignment with the saw arm. I had spend hours trying to get this right, and I was getting nowhere until I learned the trick from a book called Fine Tuning Your Radial Arm Saw, by Jon Eakes. The secret was to adjust four reference points on the table and use a crescent wrench as a lever for fine positioning. This simple trick was a huge revelation, and once I learned it, adjusting the table was done in under an hour. I'm sure I could do it in under 30 minutes now if I needed to do it again.


I'm now most of the way through testing and adjusting the saw. I hope to finish tomorrow and start ripping stock for the storm windows I need to build. I guess I just needed a big project (ripping and chopping the stock for 5 storms) with a deadline (winter) to motivate me to get this machine working. There was no way I was going to rip all that stock by hand.